skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing injection valves > < Removing and installing the fuel distributor, engine identification character BWA

Octavia Mk2

Removing and installing the fuel pressure senderG247, engine identification character BWA
Removing and installing the fuel pressure sender -G247-, engine identification character BWA
Special tools and workshop equipment required
t  Assembly tool -T10118-
t  Socket wrench insert 27 mm, e.g. -VAS 5301/7-
  Note
Observe all safety measures and notes for assembly work on the fuel, injection and ignition system as well as the rules for cleanliness → Chapter.
Removing
  WARNING
Release pressure in the high pressure area of the fuel system → Chapter.
   
–  Release the screw -5- and the nut -2-.
–  Pull off the coolant pipe -5- from the threaded pin -3-.
–  Unscrew threaded pin -3-.
–  Pull off the filler funnel -1- ( → Chapter, Pos. 3) to the top from the guide tube ( → Chapter, Pos. 4).
  Note
If there is any resistance press off with suitable tool from below.
–  Release the plug from the fuel pressure sender -G247- with the assembly tool -T10118-.
–  Screw out the fuel pressure sender -G247- with the socket wrench insert 27 mm.
Install
Installation occurs in reverse order to removal.
–  Moisten sealing cone of fuel pressure sender -G247- with clean engine oil.
Moisten thread and sealing cone of fuel pressure sender -G247- with clean engine oil.
Tightening torque: 22 Nm.
  S15-0468

Removing and installing injection valves > < Removing and installing the fuel distributor, engine identification character BWA