Skoda Workshop Service and Repair Manuals

Adjust the camber on the rear axle Special tools and workshop equipment required t  Shock absorber set, e.g. -T10001- t  Insertion tool -T10179-

–  Fitting position of the adjusting screw. –  Slacken the nut -A- of the screw connection for top suspension arm to assembly carrier.

–  To do this use insertion tool -T10179-. –  Adjust the camber by turning the eccentric bolt -B-.

–  Turn the eccentric bolt -B- using socket insert, e.g. -T10001/3-. 1 - Socket insert e.g. -T10001/3-   Note The maximum adjustment range is 90 ° from the centre position to the left or to the right.

–  Tighten the nut -A- while counterholding at the eccentric bolt -B-.

–  To do this use insertion tool -T10179-. When using the insertion tool -T10179- tighten the nut to 80 Nm. –  After the nut -A- has been tightened, inspect once again the camber value.

Tightening torques:

Assembly carrier to body (without using the insertion tool -T10179-) t  Use new nut! t  Tighten in unladen weight position!	95 Nm
Assembly carrier to body (using the insertion tool -T10179-) t  Use new nut! t  Tighten in unladen weight position!	80 Nm