skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Change brake fluid > < Bleeding the brake system using the brake filling and bleeding device, e. g. VAS 5234
Bleeding the brake system of air without using the brake filling and bleeding device
Bleeding the brake system of air without using the brake filling and bleeding device
Special tools and workshop equipment required
t  Bleeding bottle (commercially available)
t  Brake fluid → Chapter
  Note
t  Bleeding the brake system on vehicles with ABS is undertaken in the same way as for vehicles without ABS.
t  On vehicles with load-dependent brake-power regulator, move the lever of the brake-power regulator while bleeding the rear wheel-brake.
t  While bleeding continuously check the brake fluid level in the brake fluid reservoir and top up brake fluid if necessary up to the „MAX“ marking.
–  Build up pressure in the brake system by pumping repeatedly the brake pedal.
–  Fit on hose of bleeding bottle.
–  Loosen the bleeder screw by pressing on the brake pedal and bleed.
–  Tighten the bleeder screw with the brake pedal pressed down.
–  If required, repeat this procedure until the brake system is bled fully.
  Note
Repeat this procedure until the brake system is fully bled, i.e. until even the smallest air bubbles have escaped from the system.
Bleeding sequence
1.  Rear right wheel-brake cylinder/brake caliper
2.  Rear left wheel-brake cylinder/brake caliper
3.  Front right brake caliper
4.  Front left brake caliper
–  After bleeding close the relevant bleeder screw and fit dust cap.
Vehicles with ABS BOSCH 8.0, ABS BOSCH 8.2 and vehicles without ABS
–  Perform a test drive. While doing so, at least one ABS adjustment must be carried out on vehicles with ABS!
  Caution
Before the basic setting is performed, first of all the brake system must be fully bled until even the smallest air bubbles have escaped from the system.
The air bubbles would penetrate into the ABS hydraulic unit when performing the basic setting.
It is very difficult to remove these air bubbles from the ABS hydraulic unit.
Vehicles with ABS//TCS/ESP BOSCH 8.0
–  Perform basic setting of vehicle diagnosis, measurement and information system -VAS- → Chapter.
–  Perform test drive with at least one ABS adjustment!
Vehicles with ABS//TCS/ESP BOSCH 8.2i
–  Perform basic setting of vehicle diagnosis, measurement and information system -VAS- → Vehicle diagnostic tester.
–  Perform test drive with at least one ABS adjustment!
   

Change brake fluid > < Bleeding the brake system using the brake filling and bleeding device, e. g. VAS 5234